V3 set to 16/48 iriver only recorded at 16/44.1 I need to fix the headers - help

[kindms]

OK. it seems that the new recording enhancement pack i installed last week no longer will sync to a 16/48 signal. I wish I had paid more attention to the setting as it only shows 44.1 in the settings but whatever.

So when I got home last night to check out the recordings I noticed in wavelab that all the recordings show 16/44.1 and not the 16/48 i was sending them. So I forced 16/48 on playback thru my soundcard and they sound fine. I remembered reading about the 'headers' on ts.com and figured  can fix them.

I did a search and see there are a few ways to fix the headers but I didn't really see a post explaining how and where to actually change the headers from 44.1 to 48khz or what program to use can be used to do it. I have wavelab 5.0a, cd wav editor sound forge 5.0 (somewhere etc.)

Any help would be greatly appreciated. Thanks

[F.O.Bean]

open first wav in wavelab, once opened, go to 'convert sample rate' and select 48k, this shoulkd solve the puzzle

[Brian Skalinder]

open first wav in wavelab, once opened, go to 'convert sample rate' and select 48k, this shoulkd solve the puzzle

Pretty sure that will actually resample, as opposed to simply changing the header.  To only change the header in WaveLab, without resampling the data:  Edit | Audio Properties | select 48 kHz.

[F.O.Bean]

open first wav in wavelab, once opened, go to 'convert sample rate' and select 48k, this shoulkd solve the puzzle

Pretty sure that will actually resample, as opposed to simply changing the header.  To only change the header in WaveLab, without resampling the data:  Edit | Audio Properties | select 48 kHz.

ahh, thanks brian, i got those two mixed up

[kindms]

Thank you thank you tahnk you etc etc.

Ill try it when i get home.

[kindms]

open first wav in wavelab, once opened, go to 'convert sample rate' and select 48k, this shoulkd solve the puzzle

Pretty sure that will actually resample, as opposed to simply changing the header.  To only change the header in WaveLab, without resampling the data:  Edit | Audio Properties | select 48 kHz.

Worked like a charm. Thanks again. kind of embarassing I didn't think to check edit - audio - etc etc.

[Gordon]

open first wav in wavelab, once opened, go to 'convert sample rate' and select 48k, this shoulkd solve the puzzle

Pretty sure that will actually resample, as opposed to simply changing the header.  To only change the header in WaveLab, without resampling the data:  Edit | Audio Properties | select 48 kHz.

Worked like a charm.

last summer in cinci in a rush to set up (the band had started) my v3 got set to 88 whatever.  I noticed after 2 songs or so.  listening back it was so fucked up.  slow as hell.    was shocked that it fixed changing the header.