Hey y'all,
Been reading the posts & it's been helping me. Question...I'm going to try my first "matrix" recording this weekend.
I'm using: Mics>XLR>UA5 Digimod/SBD>RCA>UA5 Digimod>RCA>Archos(hard drive)
Please correct me if I'm wrong, but it looks like I adjust the mic inputs with each knob next to the XLR inputs on the UA5. And I adjust the SBD input with the knob next to the RCA input on the back of the UA5.
I know that if you raise the XLR input levels too high, the little peak light comes on. Does the same thing happen if you raise the RCA input level to hight? How can I tell if the RCA input level is too high?
Never been to the club before, so I don't know exactly where the SBD is located. If it happens to be more than 20 feet from the stage, will there be a delay? If so, how do I correct that? OR....if it's more than 20 feet from the stage, should just use the mics or SBD and not both?
Any other little tips or tricks of the trade would be helpful. Thanks again!