Become a Site Supporter and Never see Ads again!

Author Topic: AT Power Module modification request  (Read 2681 times)

0 Members and 1 Guest are viewing this topic.

Offline boa

  • Trade Count: (6)
  • Taperssection Member
  • ***
  • Posts: 579
  • Gender: Male
  • crowesbase loves you
    • crowesbase:an.amorican.archive
AT Power Module modification request
« on: February 24, 2017, 03:58:32 PM »
My AT831 mics are hard wired into the power module. The power module runs off an AA battery to power the mics and also acts as a phantom power adapter to run off 48v. Can someone replace the hard wired setup with a male mini-xlr connector set into the module and a female mini-xlr onto the ends of the mic cable?

Microtech Gefell m22 >  Babynbox > Sony m10acm
Microtech Gefell mv200/m21 > Aerco mp2 > Roland r44ocm

Offline Walstib62

  • Site Supporter
  • Trade Count: (32)
  • Needs to get out more...
  • *
  • Posts: 3266
  • Gender: Male
Re: AT Power Module modification request
« Reply #1 on: February 24, 2017, 04:51:21 PM »
Why not just terminate the mic cables to work with the IPA?

Offline boa

  • Trade Count: (6)
  • Taperssection Member
  • ***
  • Posts: 579
  • Gender: Male
  • crowesbase loves you
    • crowesbase:an.amorican.archive
Re: AT Power Module modification OR AT Mic termination request
« Reply #2 on: February 24, 2017, 04:58:36 PM »
Why not just terminate the mic cables to work with the IPA?

I was hoping to retain all the functionality and be able to use this with the IPA. Maybe I shouldn't worry about it as they are over 20 years old and would be better suited for use with the IPA.

I'll see about getting them terminated with new ta3f connectors.
« Last Edit: February 26, 2017, 11:51:57 PM by boa »
Microtech Gefell m22 >  Babynbox > Sony m10acm
Microtech Gefell mv200/m21 > Aerco mp2 > Roland r44ocm

 

RSS | Mobile
Page created in 0.045 seconds with 27 queries.
© 2002-2024 Taperssection.com
Powered by SMF