Become a Site Supporter and Never see Ads again!

Author Topic: DIY dual 6v "ecocharge"  (Read 9232 times)

0 Members and 1 Guest are viewing this topic.

Offline (((KB)))

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 361
  • Gender: Male
DIY dual 6v "ecocharge"
« on: November 25, 2006, 02:48:44 PM »
Recently switched almost all my power cables over to 4-pin then at some point, I decided to put an end to loose SLA's in my bag.  ::)

*note broke the wiring rules a little for these 6v's, but I wanted to standardize all my 4-pin cabling... used 12v wiring standard pin 1(-) pin 4(+) just incase I needed 12v at some point and run these in series.*

ANYWAY...was bored the other day and had some misc parts so I built this. I suppose you could use one 4-pin panel mount and run the SLA's in parallel for a higher capacity, but decided against that.

I will probably grab a smaller black enclosure some time and re-do it but for the time being, I used what I had on hand. Probably around $40 for the batt and parts new.

-Kevin
C3000B>GP-DMIC20>ODL312>NJB3
One of my old fav's:
http://www.archive.org/details/antibalas2004-03-27

 

RSS | Mobile
Page created in 0.076 seconds with 26 queries.
© 2002-2024 Taperssection.com
Powered by SMF