Become a Site Supporter and Never see Ads again!

Author Topic: settings on multimeter for testing 9v battery pack  (Read 1123 times)

0 Members and 1 Guest are viewing this topic.

Offline 1st set only

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2118
  • Gender: Male
  • you are what you is
    • Don Poulsen Illustration and Graphic Design
settings on multimeter for testing 9v battery pack
« on: December 09, 2004, 01:02:00 PM »
I forget anyone know?
the show is over go home please.

Offline F.O.Bean

  • Is a 4 channel slut and
  • Trade Count: (125)
  • Needs to get out more...
  • *****
  • Posts: 40663
  • Gender: Male
  • Taperus Maximus
Re: settings on multimeter for testing 9v battery pack
« Reply #1 on: December 09, 2004, 01:06:34 PM »
I forget anyone know?

well, i put mine to test 20volts DC, because there isnt a 10v setting, and make sure its on DC voltage :)
Recording Rigs:
Schoeps MK4's & MK41's ->
Schoeps | NBob 250/0 KCY's ->
Naiant +60v/Low Noise PFA's ->
DarkTrain Right Angle Stubby XLR's ->
Sound Devices MixPre-6 & MixPre-3 ->
SanDisk 128gb Extreme Pro & 2x 64gb Ultra Plus

Portable Playback Rigs:
Campfire Audio Andromeda & Dorado | Westone (2nd Generation) UM Pro 30 IEM's ->
Linum G2 SuperBax & Bax |  2x CA/ALO SPC Litz | Sony MUC-M2BT1 LDAC MMCX Cables ->
Shanling M5s & M0 | Sony NW-A35 DAP's

DAW:
Dell Inspiron 5570-5521 SLV Laptop
(Pentium i5 Processor/8gb RAM/256gb SSD)

http://www.archive.org/bookmarks/diskobean | http://www.archive.org/bookmarks/Bean420 | http://bt.etree.org/mytorrents.php

Offline Lil Kim Jong-Il

  • Trade Count: (6)
  • Needs to get out more...
  • *****
  • Posts: 6505
  • large Marge sent me
Re: settings on multimeter for testing 9v battery pack
« Reply #2 on: December 09, 2004, 03:53:58 PM »
Any DC voltage setting just above what you intend to measure will work.  If the DVM display reads over, then select the next higher setting.  If you set it too high, you won't hurt anything but you lose reading precision.  If you are using an analog meter and the needle is at either extreme, you need to adjust the range selection accordingly, then just read the appropriate scale.
The first rule of amateur neurosurgery club is .... I forget.

 

RSS | Mobile
Page created in 0.102 seconds with 26 queries.
© 2002-2018 Taperssection.com
Powered by SMF