Taperssection.com
Gear / Technical Help => TS Knowledge Base / Archive => Recording Gear => Topic started by: Bri on November 04, 2002, 03:11:55 AM
-
D7/D8 Error Codes
Code No. Block Contents
01-09 Control Motor Unable to detect the position*
10 Loading not completed
11 Unloading not completed
12 No eject
13 Mechanism deck End sensor fault (T side)
14 End sensor fault (S side)
15 DEW detected
20 Drum Drum motor won't rotate
21 Drum servo not locked
30 Capstan Capstan motor won'trotate
31 Speed not locked
40 T reel FG not detected
41 Reel S reel FG not detected
42 Measure abnormally ended
*1 If the position of the rotary encoder is not detected, the
position number for that position is preceded with 0 and this value
is displayed as the error code.
EJECT :01 Load :04 FF :07
Unload :02 REV :05 STOP :08
CASIN :03 FWD :06 REW :09
-
Just a hint from others smarter than myself...
When loading your tapes in your D8/D7/M1 turn on the light. If there is a misload the light will turn off in a short bit (while you are getting the rest of your gear ready) if not the light will remain on and you are ready to record! Neato trick.
Jonny