Become a Site Supporter and Never see Ads again!

Author Topic: Microphone Repair? - TRS 1/4 tip solder - how to re attach - SHURE 580SA  (Read 2534 times)

0 Members and 1 Guest are viewing this topic.

Offline Elguapo511

  • Trade Count: (1)
  • Taperssection Regular
  • **
  • Posts: 109
I just pulled this from a garage sale and identified the problem.  old solder....

 just wondering how to re attach correctly.

What wire goes where?  Anyone have experience with a mic like this?

Also, what is that tiny black wire? seems to be cut short.

The microphone works when I touch a few wires together.  But wondering what the T section thinks.

Check the pics and thanks for the help
« Last Edit: August 05, 2018, 05:12:00 PM by Elguapo511 »

Offline Elguapo511

  • Trade Count: (1)
  • Taperssection Regular
  • **
  • Posts: 109
update.

just stripped it.

I am confused because there are three wires and I thought there would be two.

Do I twist two together?

Which does to the t  and which to the S

Offline morst

  • I think I found an error on the internet; #UnionStrong
  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 5950
I would say from this diagram that black gets tied to the case as ground, & white AND CABLE SHIELD is signal for the high-impedance SA model.


So yeah, tie white to cable shield and run black to the mic case and see if that's right?



The SB is different.
https://www.manualslib.com/manual/920228/Shure-Unidyne-580sa.html?page=2#manual
https://toad.social/@morst spoutible.com/morst post.news/@acffhmorst

 

RSS | Mobile
Page created in 0.07 seconds with 31 queries.
© 2002-2024 Taperssection.com
Powered by SMF