Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: Kevin on June 30, 2003, 11:22:49 AM
-
Just wondering what those of you with the DMIC-20 use to power it? And any recomendations?
thanks
Kevin
-
6v 7.2a sla
this can power the dmic for a loooong time...like 6-8 hours me thinks!!!
-
bush said it, i can power my d-8 and the dmic-20 on an ecocharge bp-50 for 6-7 hrs......i ve pushed close to 8 tho..... ;) 8)
bean
-
if you dont have enough battery does it cause the sound to start crackling? because im not sure if it was my battery or something else.
-
if you dont have enough battery does it cause the sound to start crackling? because im not sure if it was my battery or something else.
soundz like more of a batt cable issue rather than the batt... ;) its been a problem of mine before..... :'(
-
The battery I used was a thing that holds 4 D batteries and the + and - wires were connected to a cable I cut off a 6 volt AC charger. only cost 4$ to make.
-
Would a bad batt cable cause the pre to display that it is powered but the recording sounds crackly sometimes or cuts out?
-
Would a bad batt cable cause the pre to display that it is powered but the recording sounds crackly sometimes or cuts out?
exactly what happened to me at phish 9-15-00.....could be something else, but soundz like the same issue...... :afro:
-
I hope thats all it is. Thanks for the help bean and do you have any streams of your 480>DMIC-20 recordings?
-
I hope thats all it is. Thanks for the help bean and do you have any streams of your 480>DMIC-20 recordings?
no streamz, but ill gladly send ya some discs..... ;)hit me an addy in a PM... 8)