Become a Site Supporter and Never see Ads again!

Author Topic: Lunatec V3 power cable connector, pin assignments, using w/EC-90  (Read 11624 times)

0 Members and 1 Guest are viewing this topic.

Offline Brian Skalinder

  • Complaint Dept.
  • Trade Count: (28)
  • Needs to get out more...
  • *****
  • Posts: 18868
  • Gender: Male

Lunatec V3 Power Cable



Switchcraft S760K
Locking connector, center pin is hot (+6/12v), sleeve is ground (-)



4-pin XLR POWER CABLE PIN ASSIGNMENTS

 6V: Pin 3 is hot (+ 6v), Pin 2 is ground (-)
12V: Pin 4 is hot (+12v), Pin 1 is ground (-)




To use properly wire your v3 power cable to work with the regulated (6v) output of the Eco-charge dual voltage EC-90 sealed lead acid battery, your 4 pin xlr must be wired as follows:

EcoCharge EC-90 V3 6 volt cable config;

Pin 1 = - / negative
Pin 2 & 4 jumped
Pin 3 = + / positive

Tip = Hot
Ring / Sleeve = Negative
« Last Edit: February 18, 2005, 01:33:58 PM by dmonterisi »
Milab VM-44 Links > Fostex FR-2LE or
Naiant IPA (tinybox format) >
Roland R-05

 

RSS | Mobile
Page created in 0.029 seconds with 26 queries.
© 2002-2024 Taperssection.com
Powered by SMF