Hi to you all!
I hope this is the right section...
Last September 1st I taped the Eagles Of Death Metal by my pcm m-10 recorder and my new Church Audio gear...
Ca14 card mics - Ugly2 preamp setting +15db - Sony PCM M-10 recorder -
Ca14 card---->input---Ugly2---output>--->line in---PCM M-10
In the afternoon I tried my gear for the first time and channel right didn' work, after some tests I understood the problem was the cable (in a connector the right channel contact touched with the ground).
During the tests looking for the failure I turned with a screwdriver the two trimmers of the Ugly2 preamp, now they are in max position.
I'm a newbie and I don't know the right setting... How must I setting the Ugly2? how are they must adjust? I keep them to maximum... is it correct?
How can I adjust at the right recording level before start? I noticed the volume on M-10 recorder didn't adjust the level... is it right?
I put the mics on the hat and I stayed in front of stage 10-15 meters from it My EODM recording was a bit distorted, on my m10 the 2 green leds were turned on and the 2 red leds flashed anytime, but if tried to adjust the level by the volume didn't change.
Many thanks in advance for your kind replies...