Become a Site Supporter and Never see Ads again!

Author Topic: AT Power Module modification request  (Read 195 times)

0 Members and 1 Guest are viewing this topic.

Offline boa

  • Trade Count: (5)
  • Taperssection Member
  • ***
  • Posts: 439
  • Gender: Male
  • crowesbase loves you
    • crowesbase
AT Power Module modification request
« on: February 24, 2017, 03:58:32 PM »
My AT831 mics are hard wired into the power module. The power module runs off an AA battery to power the mics and also acts as a phantom power adapter to run off 48v. Can someone replace the hard wired setup with a male mini-xlr connector set into the module and a female mini-xlr onto the ends of the mic cable?

"Did anyone else just see a gnome with two bottles of scotch walk by?"

Offline Walstib62

  • Trade Count: (23)
  • Needs to get out more...
  • *****
  • Posts: 2220
  • Gender: Male
  • Archivist-Virginia Key Grassroots Festival
Re: AT Power Module modification request
« Reply #1 on: February 24, 2017, 04:51:21 PM »
Why not just terminate the mic cables to work with the IPA?

Offline boa

  • Trade Count: (5)
  • Taperssection Member
  • ***
  • Posts: 439
  • Gender: Male
  • crowesbase loves you
    • crowesbase
Re: AT Power Module modification OR AT Mic termination request
« Reply #2 on: February 24, 2017, 04:58:36 PM »
Why not just terminate the mic cables to work with the IPA?

I was hoping to retain all the functionality and be able to use this with the IPA. Maybe I shouldn't worry about it as they are over 20 years old and would be better suited for use with the IPA.

I'll see about getting them terminated with new ta3f connectors.
« Last Edit: February 26, 2017, 11:51:57 PM by boa »
"Did anyone else just see a gnome with two bottles of scotch walk by?"

 

RSS | Mobile
Page created in 0.076 seconds with 24 queries.
© 2002-2017 Taperssection.com
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company