Become a Site Supporter and Never see Ads again!

Author Topic: D7/D8 Error Codes  (Read 1470 times)

0 Members and 1 Guest are viewing this topic.

Offline Bri

  • Complaint Dept.
  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 3226
  • Gender: Male
  • There is nothing you can hold, for very long.
D7/D8 Error Codes
« on: November 04, 2002, 03:11:55 AM »
D7/D8 Error Codes

Code No.      Block         Contents

01-09         Control Motor      Unable to detect the position*

10                  Loading not completed
11                  Unloading not completed
12                  No eject
13         Mechanism deck           End sensor fault (T side)
14                  End sensor fault (S side)
15                  DEW detected
20         Drum         Drum motor won't rotate
21                  Drum servo not locked

30         Capstan              Capstan motor won'trotate
31                  Speed not locked

40                  T reel FG not detected
41         Reel         S reel FG not detected
42                  Measure abnormally ended               


*1 If the position of the rotary encoder is not detected, the
position number for that position is preceded with 0 and this value
is displayed as the error code.  

EJECT   :01      Load   :04      FF   :07
Unload   :02      REV   :05      STOP   :08
CASIN   :03      FWD   :06      REW   :09

jpschust

  • Guest
  • Trade Count: (0)
Re:D7/D8 Error Codes
« Reply #1 on: November 04, 2002, 09:10:56 AM »
Just a hint from others smarter than myself...

When loading your tapes in your D8/D7/M1 turn on the light.  If there is a misload the light will turn off in a short bit (while you are getting the rest of your gear ready) if not the light will remain on and you are ready to record!  Neato trick.

Jonny

 

RSS | Mobile
Page created in 0.077 seconds with 25 queries.
© 2002-2017 Taperssection.com
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company