Become a Site Supporter and Never see Ads again!

Author Topic: How to make AES>7pin  (Read 12686 times)

0 Members and 1 Guest are viewing this topic.

Offline Swanny

  • Trade Count: (2)
  • Taperssection Member
  • ***
  • Posts: 440
  • Gender: Male
    • Some shows...
How to make AES>7pin
« on: October 16, 2003, 09:32:25 PM »
I use it for my D8 (use prosumer out on V3, the other will give you a copy prohibit warning)

Ok here's what you need:

1-rt-angle female XLR
1-junk 7-pin head (mine used to be an optical, someone sent me when I asked on Oade board a while back, any will work)
1-meter Canare 110ohm cable
1-female RCA end on cable (I had a couple on a cable I had here)
shrink wrap, solder, & small soldering iron
Patience, take your time & do it right...

first connect the RCA to the stripped ends of the Canare cable Shield to ground (white) Center to red, solder & shrinkwrap, leaving enough wire exposed to connect to the pins on the 7-pin

open 7 pin, hack out whatever you have to to see the pin heads, you will also have to widen the cable opening a bit on the 7-pin with an exacto knife to make it close(you want the insulation on the canare cable to end just outside the 7-pin).

--1--2--3--4---
l  o   o  o   o   /
l  o   o  o    /
--5--6--7--

1. connect pins 3 & 6 (enable digital in)
2. connect the ground (I used the white shielded wire) to either the piece you used to bridge these pins, or pin 6
3. connect orange shielded wire to pin 5
4. put the top back on 7pin
tip: tin the ends of the wire first, then bend 90 degrees with needle nose

For the XLR end:
1. connect pin 2 to the orange
2. connect pin 3 to the white (ground)
leave pin 1 shield unused

Test it out, then when you know it works open the 7 pin and fill with silicone.
Schoeps MK5/8 > KC5 > CMC6> Oade M148/Aerco MP-2 > Mytek 24192 > Tascam dr-100 mkiii

 

RSS | Mobile
Page created in 0.049 seconds with 28 queries.
© 2002-2024 Taperssection.com
Powered by SMF