Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Wiring a balanced 1/4" to XLR question  (Read 1991 times)

0 Members and 1 Guest are viewing this topic.

Offline Zaphod

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1738
  • Gender: Male
Wiring a balanced 1/4" to XLR question
« on: October 14, 2004, 08:45:08 PM »
Searched to no avail, just wonering if there is a standard schematic to wire such cable.

I know to make sure that the sleeve of the 1/4" inch is to be wired to the pin 1 for ground, but what about the other pins? I suppose it shouldn't matter as long as the ground is right?

Thanks.
Logged
we are the people the rescuers will never find

Offline leegeddy

  • Trade Count: (1)
  • Taperssection All-Star
  • ****
  • Posts: 1953
  • Gender: Male
Re: Wiring a balanced 1/4" to XLR question
« Reply #1 on: October 14, 2004, 08:49:17 PM »
http://www.montarbo.com/pdf/connettori.pdf

Tip: Pin 2
Ring: Pin 3
Shield: Pin 1

marc
Logged
"I'm a taper, he's a taper. Wouldn't you like to be a taper too?"
"Mics? What mics? This is my hat."

Offline Zaphod

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1738
  • Gender: Male
Re: Wiring a balanced 1/4" to XLR question
« Reply #2 on: October 14, 2004, 08:59:06 PM »
Printed that one out, thanks a bunch Marc, and +T.
Logged
we are the people the rescuers will never find
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.142 seconds with 31 queries.
© 2002-2024 Taperssection.com
Powered by SMF