Topic: What wire should I use for my SLA?

[tim in jersey]

I'm building a couple 6V SLA's for my V3. Looking for advice as to what to use for wire.

Stopped by the local RatShack this past weekend and the only 2 conductor wire they carry is speaker wire. Will speaker wire work?

Tried mouser as well, but the wire and cable category has 6000+ entries and I really don't know what I'm looking for anyways.

Any insight would be appreciated.

[BCostigan]

Speaker wire will work.....I also have used lamp cord.   If you have a simple old extension cord laying around you can always hack the ends off and just use the cable (same for an old lamp)   I usually find something I'm not using around the house to come up with parts for most everything!

[BobW]

I like a sleeved two-conductor. It gives a little extra protection.

I don't know where in NJ you are.....
Denville has Lashen, Raritan has a good parts store, and so does Patterson.
Home Depot or Lowe's can stock good low-voltage cable as well.

Don't forget to get some plastic water main to make a hulahoop, while you're at Home Depot    

[leegeddy]

I'm building a couple 6V SLA's for my V3. Looking for advice as to what to use for wire.

Stopped by the local RatShack this past weekend and the only 2 conductor wire they carry is speaker wire. Will speaker wire work?

Tried mouser as well, but the wire and cable category has 6000+ entries and I really don't know what I'm looking for anyways.

Any insight would be appreciated.

i have some sleeved wires that i've used for several SLA wiring projects.  got about 100' at home.  lmk if you want few feet of it.

marc

[rabhan]

go to any hardware store and get lampcord.

[jpschust]

i used some heavier stiffer wire from rat shack just because i feel like stiffer wire is easier to solder in place in those tiny holes in xlr plugs