Taperssection.com
Gear / Technical Help => TS Knowledge Base / Archive => Remote Power => Topic started by: (((KB))) on November 25, 2006, 02:48:44 PM
-
Recently switched almost all my power cables over to 4-pin then at some point, I decided to put an end to loose SLA's in my bag. ::)
*note broke the wiring rules a little for these 6v's, but I wanted to standardize all my 4-pin cabling... used 12v wiring standard pin 1(-) pin 4(+) just incase I needed 12v at some point and run these in series.*
ANYWAY...was bored the other day and had some misc parts so I built this. I suppose you could use one 4-pin panel mount and run the SLA's in parallel for a higher capacity, but decided against that.
I will probably grab a smaller black enclosure some time and re-do it but for the time being, I used what I had on hand. Probably around $40 for the batt and parts new.
-Kevin