Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: rodeen on May 06, 2014, 08:57:09 PM

Title: Mini-Me Gain Structure
Post by: rodeen on May 06, 2014, 08:57:09 PM

Quick question for all you current or past Mini-Me owners, am I correct in understanding that for loud, PA recordings that we do, the Mini-Me needs to be opened up and jumpers set to the low gain structure setting?

TIA!

Title: Re: Mini-Me Gain Structure
Post by: hi and lo on May 06, 2014, 09:05:50 PM

Yes, you should absolutely set the gain structure to low via the internal jumpers. There's a good post on here somewhere about the jumper positions. IIRC, the manual isn't very clear about the which position is which.

Title: Re: Mini-Me Gain Structure
Post by: rodeen on May 06, 2014, 09:14:33 PM

Thanks!  I thought it was most likely discussed here sometime in the past but I wasn't having much luck with using google to search TS.com or the builtin search.
And you are right, the manual is pretty light on everything.  Thanks again!

Title: Re: Mini-Me Gain Structure
Post by: Cobiwan on May 24, 2014, 04:51:50 PM

check your manual, it shows a pic of where they are located. Factory preset is to high or forward toward the front panel. You need to get some tweezers and pull them straight up and then move them back towards the rear of the mini me. Very easy