Gear / Technical Help > Cables
Cabling for a Tascam DR40
pigpen2604:
Howdy
My current set up is - CA14s>CA9200>Edirol R09HR.
My edirol is on its last legs and I am looking at the DR40 as a replacement.
My question is what cabling would I need from the CA9200 to the DR40?
The output on the pre is 3.5mm.
All my taping is >:D so I'd prefer as little bulk in cabling as possible.
Thanks
tgakidis:
Mini 1/8” (straight or right angle) > chopped xlrs (straight or right angle)
daspyknows:
Why a DR40 if you are running >:D? I use the DR-2D which is mini to mini. Its smaller than DR40
pigpen2604:
--- Quote from: daspyknows on April 13, 2018, 06:37:59 PM ---Why a DR40 if you are running >:D? I use the DR-2D which is mini to mini. Its smaller than DR40
--- End quote ---
Because I can't find a DR-2D and I fancy having a recorder with dual recording.
daspyknows:
--- Quote from: pigpen2604 on April 14, 2018, 07:30:21 AM ---
--- Quote from: daspyknows on April 13, 2018, 06:37:59 PM ---Why a DR40 if you are running >:D? I use the DR-2D which is mini to mini. Its smaller than DR40
--- End quote ---
Because I can't find a DR-2D and I fancy having a recorder with dual recording.
--- End quote ---
I just picked up an extra DR-2D on ebay for $100 (have 5). I offered it to someone else but he may get the new Roland. If he doesn't want it we can figure something out since I will be in London in July and can ship from there.
Navigation
[0] Message Index
[#] Next page
Go to full version