Gear / Technical Help > Microphones & Setup
Will Rycote INV-2 fit the Schoeps Nbob actives?
waltmon:
https://daleproaudio.com/products/rycote-inv-2-invision-indoor-microphone-suspension-for-studio-and-conference
Been looking at these mounts.. It appears they may fit...these are pretty small...just over 1.5 " both width and height
Bean??
jbell:
You should get an active bar and just use one of these!
https://www.bhphotovideo.com/c/product/880280-REG/Rycote_041118_INV_8_Microphone_Suspension.html?ap=y&c3api=1876%2C92051677682%2C%2C&gclid=EAIaIQobChMIsuTo5MK62gIVjVqGCh2URgqfEAQYASABEgIt2vD_BwE
waltmon:
I'm aware of the Shapeways bars etc...I need to look again. I'm planning to run the MK41 actives with the U89's 4 channel - Ive just envisioned it a bit different
Thank you - checking out this evening
goodcooker:
--- Quote from: waltmon on April 14, 2018, 02:51:07 PM ---https://daleproaudio.com/products/rycote-inv-2-invision-indoor-microphone-suspension-for-studio-and-conference
Been looking at these mounts.. It appears they may fit...these are pretty small...just over 1.5 " both width and height
Bean??
--- End quote ---
I use these for my MBHO actives. The holder grabs on to the mini XLR connector with just enough room to get it to stay in there. These were designed for the LEMO connector on the CCM series - as pictured in your link. It's too big for the nipple on the collette and the other side of the holder would just have the cable laying in it. They are actually a little bigger than they look. The base is a couple of inches high as well so the whole thing is about 3.5 inches high. I really like them for the HOs.
I use a Vark bar, nBob SGC clips and a riser in a A20 shockmount for my MK41s.
I could take a picture of both of my setups side by side if you need some help visualizing what I'm saying here.
nolamule:
The SRS bars are the only way to fly...light, durable, and inexpensive.
Navigation
[0] Message Index
[#] Next page
Go to full version