Become a Site Supporter and Never see Ads again!

Author Topic: EAC Configuration Check  (Read 2448 times)

0 Members and 1 Guest are viewing this topic.

Offline zhianosatch

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 8995
  • Gender: Male
  • god-damned hippies!
EAC Configuration Check
« on: November 13, 2003, 12:03:13 AM »
Original thread hyah:;action=display;threadid=9354

Bill posted:

I have to admit some fault. I thought that I was good to go using EAC to get bit perfect extractions and that all was good. Then I read this:

So fortunately...I don't trade much. I don't know how much of an effect my original settings had on the EAC's I did in the past. I'm still not 100% that I do have it set now. I read, and re-read the instructions found:


2004-07-03 | Edited by Brian Skalinder
and here:
Out-dated link.  New one:  The Coaster Factory

I set the read offset to 0, ripped a studio disk, burned that disk, ripped tracks off of the second disk, and compared the WAV files using the feature in EAC. At first I came up with 92 missing samples on the original rip. I adjusted my read offset to +92.

Then I re-ripped the second disk and compared the WAV files again. This time I got no errors. I good now?

npsinboro replied:

That's exactly what yer supposed to do Bill.

For further sanity checks you could do a file compare in DOS between the two .wav's you extracted from different disks to ensure the files are identical (not sure what EAC uses).

If in windows > Start > Run > 'cmd'

In DOS window:
C:\> FC filename1 filename2

Similar format to the unix "diff" command.
« Last Edit: February 14, 2005, 11:18:18 AM by dmonterisi »


RSS | Mobile
Page created in 0.082 seconds with 24 queries.
© 2002-2018
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company