Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: markrsmith on February 19, 2012, 11:23:26 AM
-
Any suggestions for initial settings on the V2 and 661, running Bsc2>V2>pmd661? Using the V2 for the first time tonight at a BHTM show. Thanks!
-
Any suggestions for initial settings on the V2 and 661, running Bsc2>V2>pmd661? Using the V2 for the first time tonight at a BHTM show. Thanks!
the XLR line in has a max of +15dbu (http://taperssection.com/index.php?topic=139705.msg1828058#msg1828058)
the bsc2 are ~20mv/pa (-34 ref) (http://busmanaudio.com/bsc2.htm), this means at about 120-124spl, you're pushing the -5dbu range (http://www.sengpielaudio.com/calculator-transferfactor.htm) (which in my experience is close to typical for the max peaks of concert taping and at least a nice starting point for calculations).
So given this information, if I were you, (assuming no gain on the 661) I'd start at 20db of gain on the big knobs and trim it back about a quarter of the way (so -3db) and then adjust from there after the first song.
-
Thanks
-
Make sure to set the XLR input switch to Line, set the 661 gain knob to 6-7, then bring the V2 gain up until you get good levels on the recorder and you will be good to go.