Taperssection.com

Gear / Technical Help => Cables => Topic started by: OOK on August 02, 2016, 07:33:00 PM

Title: Interesting Vid for you cable makers....
Post by: OOK on August 02, 2016, 07:33:00 PM
Its Tye from inner fidelity...

https://www.youtube.com/watch?v=KV_TIHlSAbA
Title: Re: Interesting Vid for you cable makers....
Post by: hi and lo on August 03, 2016, 02:25:32 AM
An 8-minute video for a piece of wood with holes drilled in it?  :lol:
Title: Re: Interesting Vid for you cable makers....
Post by: ScoobieKW on August 03, 2016, 02:36:11 AM
The best holder for a connector is the opposite gender of the same connector.

Cable testers work well, and allow you to test as you build.
Title: Re: Interesting Vid for you cable makers....
Post by: Fried Chicken Boy on August 03, 2016, 12:06:06 PM
An 8-minute video for a piece of wood with holes drilled in it?  :lol:

A $40 piece of wood, at that.
Title: Re: Interesting Vid for you cable makers....
Post by: DigiGal on August 03, 2016, 02:33:21 PM
An 8-minute video for a piece of wood with holes drilled in it?  :lol:

A $40 piece of wood, at that.

Ha, I have one ordered it a few years back when Radio World magazine did an article on it. Bottom line for me is I found it useless in practice and don't use it at all.

My
Panavise is indispensable!
Title: Re: Interesting Vid for you cable makers....
Post by: SacredMetal on October 04, 2016, 12:14:11 AM
If you were wiring hundreds of connectors then the price tag would be worth it. I used to make gigs to do wire tying & solder work similar to this back in the 70's for Crumar Keyboards and an airplane factory I worked for (separate times), but we made them out of blocks of aluminum so they acted as a heat sink as well & lated forever.
Title: Re: Interesting Vid for you cable makers....
Post by: datbrad on October 06, 2016, 07:04:40 AM
I made one of those over three years ago, but its not as nice looking. Mine is oriented horizontally and has the opposing gender panel connectors mounted on the block of wood. This seems better to me for two reasons. First, most soldering points on connectors are hollow and often open on the top half, XLRs and DINs for example. I can't see how soldering with the connector on it's end would work. The solder will run down into the female solder side ends of each pin, and the male solder points would also be odd to try and solder down on them using this guy's block. Mine holds the connector in the orientation needed to hold the solder where it's supposed to end up. Also, using panel connectors to mount the one being soldered serves as a heat sink and helps to cool the hot pins faster after completing the work. I'll post a picture sometime if I remember to. Also, I have some of those helper clips and never use them. I can hold the wire down with the tip of the iron and use my left hand to apply the solder in less time than it takes to setup with those clips. Funny how different people view doing work like this is.