Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: MakersMarc on July 06, 2018, 06:10:39 PM
-
Anyone run schoeps verticals>babynbox>Marantz 620? If so would love to know where you set levels for >:D for soft stuff and loud rock up close. Thanks!
-
I would run between -20 and -10 but always with the pad engaged.
From ---> https://www.oade.com/Tapers_Section/faq-general.html
It's important to understand the MIC ATTN settings in the PMD 620 and 661 are not pads, they actually alter the gain of the preamp. Always use the least amount of gain that will allow you to get to 0dBFS, this means using the largest negative number (i.e. -18dB or -24dB). This does 2 things, it lowers noise and distortion plus it prevent input overload or "brickwalling". It's OK to set the PMD 620 or 661 record level control at 10 as long as your meters never show an over load. This is preferred to using a higher gain setting( smaller negative number) and setting the record level control to 6. If you cannot get enough signal level, then and only then switch to the next highest gain setting (i.e. -12dB)
-
Doug said run -24 what's I'm trying to figure out where to set the record level control, I didn't ask the question right. :facepalm:
-
I always cable mine into the line in jack. And i try not to let the levels go past 12 and then normalize in post. Mine is a Oade modded deck and this was his suggestion for concert recording. I find that works very well