Gear / Technical Help > Recording Gear
Tascam DR-05 settings guide
emalvido:
Hello to all
My two mic options using recently purchased a Tascam DR-05
OKMII/R>A3>DR-05
SP-CMC-8>ST-9100>DR-05
Loud rock music:
With the OKM´s manually, the recording level is on the minimum, but the meters hit all the way up, usually the red led blinks peaking and overloads if its extra thump/loud overloading.
The A3 battery box does not have levels
Is there a way to prevent this? wich one recomend to use?
-Peak Reduction
-Auto Level
-Limiter
When taping with the SP-CMC-8>ST-9100
I can turn the level up/down on the ST-9100 and can record with no overload problems.
Also, if there is a settings guide recording with the DR-05 could some one point me where to look it?
Thanks
ycoop:
Do you have the DR-05 set to line in or mic in?
emalvido:
I plug it in the only one aviable wich is located on the top of the unit:
MIC/EXT IN Jack
ycoop:
There’s a setting for “mic power.” If you turn that off it should treat the input as line level.
The Other Chris:
My battery box is dead, running the Dr-05 at a loud concert, with the mic power off I'm barely getting levels, any advice on whether or not to run with the mic on option? Using CA 11 cards. Thanks!!!
Navigation
[0] Message Index
[#] Next page
Go to full version