Gear / Technical Help > Microphones & Setup
Replacement Manfrotto screw?
(1/1)
vwmule:
Brought stand to Panic last night and noticed the locking screw was gone -- strange as I don't use the stand that often. Anyone know the replacement part number? I can't seem to find.
It's the red piece shown in picture.
https://www.bhphotovideo.com/c/product/644444-REG/Manfrotto_1004BAC_Alu_Master_3_Riser.html
perks:
I think its in the diagram here....
https://www.manfrottospares.com/1004bac-parts.html
vwmule:
Thanks. Says discontinued. I'll call B&H.
danny3:
I lost that same screw from the same stand at a festival a while back. After retracing my steps and scanning the ground for over an hour I gave up, only to find it in the grass below my tailgate.
tivva:
--- Quote from: vwmule on March 17, 2019, 10:04:49 PM ---Thanks. Says discontinued. I'll call B&H.
--- End quote ---
just go to your local hardware store...it's either fine or coarse thread? might even have the correct wingnut size like i found....
total cost .89 cents...good luck!
Navigation
[0] Message Index
Go to full version