Gear / Technical Help > Microphones & Setup
My SRS 3D printed microphone bars
noahbickart:
https://www.shapeways.com/product/W5BGSBPST/hybrid-schoeps-nbobs?li=shareProduct
Newest Bar, meant for OTS PAS taping with 60° angles. 21cm for the mk41v and 30cm for the mk22 (Stereophonic zoom used to match Cardioids in DIN Recording angle, with the different capsules and angles). This bar can accommodate big windscreens for outdoor use.
https://www.shapeways.com/product/WLTJKUU2H/din-nos-combo-mount?optionId=60523604
DIN/NOS Combo Mount for Schoeps with NBob active cables. Upper pair (20cm) for side-address capsules. Lower pair (30cm @ 90°) for end-address capsules.
https://www.shapeways.com/product/MPPBSUT26/ms-xy-schoeps-with-nbob-actives?optionId=60409239
X/Y or M/S for Schoeps vertical capsules.
https://www.shapeways.com/product/DQ3TZRTAK/hybrid-schoeps-w-n-bob-actives?optionId=60996905
Mounts for 3 Pairs of Schoeps. Outside pair: 70 degrees 35 cm (for the mk22, essentially the same Recording angle as Cards NOS, but modified using the stereophonic zoom for narrower angle and the mk22), plus two vertical pairs, at 30 cm
and 20 cm. This bar is for indoors only, and can not accommodate big windscreens for outdoor use.
dactylus:
Nice bars Noah! I think that I'm going to pick up the newest bar that you posted for my mk22's & mk4V's.
noahbickart:
--- Quote from: dactylus on July 28, 2017, 10:31:06 AM ---
Nice bars Noah! I think that I'm going to pick up the newest bar that you posted for my mk22's & mk4V's.
--- End quote ---
That bar was designed for the mk41v but would likely work with the 4v as well.
I'm going to run mk22 and mk41v pairs on that bar along with a mk4v/mk8 M/S rig on Sunday at Phish
fobstl:
The bars that Scott is creating are truly awesome. I currently have him working on a Kangol mount that looks like it is going to be pretty cool.
LiveOnTape:
--- Quote from: noahbickart on July 28, 2017, 09:16:23 AM ---
https://www.shapeways.com/product/MPPBSUT26/ms-xy-schoeps-with-nbob-actives?optionId=60409239
X/Y or M/S for Schoeps vertical capsules.
--- End quote ---
The M/S clip looks really cool. Do you know the size of the clips for nBobs? I use two AKG M90 active cables with CK94 figure 8 caps for MS/Blumline. They look very similar, and have a 12mm clip. Would this fit? or do you do custom orders to make one that does?
Also, are those just small clips back to back with 20mm clip, then just a 20mm post (three pieces)? If so, I can see these being used in my double M/S rig where I want to use a back-to-back clip onto the AKG's 19mm body (facing backwards).
Great work,
L
Navigation
[0] Message Index
[#] Next page
Go to full version