Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: boa on February 24, 2017, 03:58:32 PM

Title: AT Power Module modification request
Post by: boa on February 24, 2017, 03:58:32 PM

My AT831 mics are hard wired into the power module. The power module runs off an AA battery to power the mics and also acts as a phantom power adapter to run off 48v. Can someone replace the hard wired setup with a male mini-xlr connector set into the module and a female mini-xlr onto the ends of the mic cable?

(http://crowesbase.com/at831b.jpg)

Title: Re: AT Power Module modification request
Post by: Walstib62 on February 24, 2017, 04:51:21 PM

Why not just terminate the mic cables to work with the IPA?

Title: Re: AT Power Module modification OR AT Mic termination request
Post by: boa on February 24, 2017, 04:58:36 PM

Quote from: Walstib62 on February 24, 2017, 04:51:21 PM

Why not just terminate the mic cables to work with the IPA?

I was hoping to retain all the functionality and be able to use this with the IPA. Maybe I shouldn't worry about it as they are over 20 years old and would be better suited for use with the IPA.

I'll see about getting them terminated with new ta3f connectors.