Become a Site Supporter and Never see Ads again!
« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: minime overheating issue?  (Read 5564 times)

0 Members and 1 Guest are viewing this topic.

Offline bearcobb

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 32
  • Gender: Male
  • neumann crew
    • my list
Re: minime overheating issue?
« Reply #15 on: October 26, 2004, 06:48:33 PM »
ok, im not sure who made the actual power cables, they just have neutrik connectors  that say "NCMX".

anyway, i was told to power it up with the cover off and see if it got hot and if i could feel where the heat was eminating from, but after about 15 minutes it stayed cool to the touch...so i dont know anything else really new to share.
Logged

Offline Daryan

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1078
  • Gender: Male
Re: minime overheating issue?
« Reply #16 on: October 26, 2004, 06:55:53 PM »
Here'e the direct address for Gary. I guess my experiences with apogee haven't been like Jonny's, mine have all been really really good (though I probably have had about four compared to others ;))

gary@apogeedigital.com
Logged
Microtech Gefell 200/210->Zaolla Silverlines->Fostex FR-2 (oade modified plus other self mods)

Playback: Bolder modified Squeezebox SB3 (building linear power supply)->Bolder Cable Modified Panasonic XR-45 with bybee's->Bolder Nitro speaker cables->VMPS Audio super modified 626r's, VMPS Larger SUB, 1000w class AB sub amp
Tweaks: isolation and room treatments, silclear, BPT 1.5r Power Conditioner (modified), isoblocks, vibrapods, many others

Offline bearcobb

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 32
  • Gender: Male
  • neumann crew
    • my list
Re: minime overheating issue?
« Reply #17 on: October 30, 2004, 10:40:08 PM »
here is the response i got...

Quote
If the MiniMe gets hot, this would indicate that
it was receiving power that was either too high
of a voltage, or the power connector was
reversed. Finally, it's possible that the unit
failed.

Does the unit operate correctly at the moment? Does it get hot now?
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.037 seconds with 31 queries.
© 2002-2024 Taperssection.com
Powered by SMF