Become a Site Supporter and Never see Ads again!

Author Topic: ssm shockmounts rubber bands  (Read 1446 times)

0 Members and 1 Guest are viewing this topic.

Offline jkbyram

  • Taperssection Underachiever
  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4552
ssm shockmounts rubber bands
« on: March 30, 2007, 07:55:38 AM »
anyone had to order new bands for these shockmounts yet? where did you get them if you did? i have been unable to locate a place to order them. have you done anything to help them stay on better?

Offline flipp

  • resident curmudgeon
  • Trade Count: (17)
  • Needs to get out more...
  • *****
  • Posts: 4285
Re: ssm shockmounts rubber bands
« Reply #1 on: March 30, 2007, 10:11:55 AM »
HAven't had to replace any of them yet so can't help with where to get them. I did remove two from each end so there are two per end left and have had no problem with the bands coming off. Easier for me to get the mics in with only two bands per end as opposed to the four bands per end that the mounts shiip with. Still plenty of support for the mics with only two bands.

If you have a local VW repair shop, see if they have some spare air-cooled type 2 push rod tube seals. They are about the same size as the SSM shock bands and should last longer than the original bands. Another alternative would be to visit your local hardware store/home center and look through their supply of O-rings for a usable substitute/replacement.

 

RSS | Mobile
Page created in 0.048 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF