Become a Site Supporter and Never see Ads again!

Author Topic: TK Audio DP1 (rack mount, AC only)  (Read 2125 times)

0 Members and 1 Guest are viewing this topic.

Offline sunjan

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 2006
  • Gender: Male
  • Taping since 1988, 28 years of fine recordings...
    • Just a handful of stuff I put on etree
TK Audio DP1 (rack mount, AC only)
« on: August 21, 2012, 07:23:11 AM »
This model has been out for some years.
I guess it's not ideal for live use, due to form factor and AC restriction.
But perhaps some official band archivist could find it interesting.
Street price $1449

http://www.tkaudio.se/index.php?option=com_content&view=article&id=4&Itemid=4


The DP-1 is a dual channel preamp based on a unique hybrid design including both vintage and modern circuits. Germanium and silicon transistors, along with integrated circuits, make the sound character expand over several decades. The midrange crunch of the germanium sound of the mid 60's, the low mid punch and thick sound associated with British class-A from the early 70's and the modern tone from the 80's and 90's; all in the same box.

The input-stage is built around a high quality Swedish Lundahl transformer and an IC that operates in class-A. The preamp section is followed by a germanium unity-gain stage for coloration. Finally the DP-1 has two different output stages, an electronically balanced output stage or a discrete transformer-balanced class-A stage, built around a heavy Carnhill output transformer. The vintage class-A mode produces a fat and punchy sound with mid range character and a warm top-end; the germanium mode adds even more harmonics to the sound. The IC-based output stage is less colored and perfect for clean amplification.
With up to 80 dB gain the DP-1 can handle quiet sound sources like ribbon microphones. High impedance inputs are positioned on the front for easy access when connecting guitar, bass or synthesizers. It's also possible to crank up the input gain really loud and run a hot signal through the preamp to make it distort, and then use the output volume control to lower the output gain. DP-1 offers a unique set of flavors at a very sensible price.

Key Features:
Unique hybrid design offering plenty of flavor
Up to 80 dB gain available
Vintage class-A mode selectable
Germanium drive available
Lundahl inputtransformers
Carnhill output transformers
Hi-Z inputs on the front
Sensibly priced
   


Features:
Hi-Z input, instrument input with more than 1Mohm input impedance.
Impedance switch, 1200ohm / 300ohm.
48v phantom power.
Stepped gainswitch in 5dB steps, inputrange +5dB to -50dB. -30 to -80dB with +30dB boost.
+30dB gainboost switch.
Germanium drive, inserts a germanium unity-gainstage after the inputstage.
Output levelcontrol.
Phase-reverse switch.
Vintage transformerbalanced class-A or a electronic balanced outputstage.
Input impedance: 1.600ohm / 400ohm.
Max output: +26dB @ 600ohms load.
All switches are illuminated.
Internal, regulated powersupply with a toroidal transformer. 230v. Main voltage is selectable between 115v / 230v.
Mics: A-51s LE, CK 930, Line Audo CM3, AT853Rx (hc,c,sc),  ECM 121, ECM 909A
Pres: Tinybox, CA-9100, UA5 wmod
Recorders: M10, H116 (CF mod), H340, NJB3
Gearbag: High Sierra Corkscrew
MD transfers: MZ-RH1. Tape transfers: Nak DR-1
Photo rig: Nikon D70, 18-70mm/3.5-4.5, SB-800

 

RSS | Mobile
Page created in 0.044 seconds with 29 queries.
© 2002-2024 Taperssection.com
Powered by SMF