Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Mini-XLR to 4-Pin XLR?  (Read 2181 times)

0 Members and 1 Guest are viewing this topic.

Offline taper420

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1039
  • Gender: Male
Mini-XLR to 4-Pin XLR?
« on: November 03, 2008, 10:20:46 AM »
I just got a bunch of ecocharge's with 4-pin XLR connectors. The power cable for my V3 has a mini-XLR connector.
1. Are there commercial available adapters that are wired correctly?
2. What is the correct wiring if I want to make one myself?

TIA
Logged

Offline dbindc

  • Trade Count: (4)
  • Taperssection Regular
  • **
  • Posts: 53
  • Gender: Male
Re: Mini-XLR to 4-Pin XLR?
« Reply #1 on: November 03, 2008, 01:09:17 PM »
Not sure if your V3 is wired for 12v or 6v but...
Ecocharge 12v are pin 4 (+) pin 1 (-).  6v are pin 3 (+) pin 2 (-)
Logged
Gefell M300, DPA 4022 and 4061
MBHO 603A/648 + KA200, KA500, KA100DK, KA400, KA800, K20, vintage MB omni & cardioid capsules under Peerless and Unitra brands  Audix SCX1  Josephson branded MBHO/Peerless 640
preamps and recorders SD MP2 Naiant Littlebox & Tinybox  Edirol R44  Sony M10 CA-Ugly

Offline taper420

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1039
  • Gender: Male
Re: Mini-XLR to 4-Pin XLR?
« Reply #2 on: November 03, 2008, 05:44:03 PM »
Thanks.
The V3 is 6v, but from my understanding there's no difference in wiring, or operation for that matter, other than the battery meter calibration.
The ecocharge's are 7.2v, so I'm going with pin 3 (+), pin 2 (-).
I suppose I'll just take off the mini-XLR for my V3 cable, and wire a 4-pin XLR on.
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.052 seconds with 31 queries.
© 2002-2024 Taperssection.com
Powered by SMF