Become a Site Supporter and Never see Ads again!

Author Topic: Garage sale find : Shure 315 . But how do I diy the cable?  (Read 242 times)

0 Members and 1 Guest are viewing this topic.

Offline Elguapo511

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 9
Garage sale find : Shure 315 . But how do I diy the cable?
« on: November 16, 2017, 11:57:12 PM »
Hey there everybody.
I came across a few great mics at a garage sale and one of them is a Shure 315 gradient ribbon model.

Great looking.  Found a few Billie Holiday photos with it.... 

It did not come with the chord but I tracked down the connection parts and am not quite sure how to wire this all up.
I need to go from amphenol 3 pin to xlr.

The mic has the amphenol female. And I tracked down the correct amohenolmale.
So I want to make this amphenol male to xlr cable.

Would it be okay  to simply buy an xlr cable , slice off the end I don’t need and attach those to the amphenol connector ,  and then to the mic?

Offline EmRR

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 15
    • ElectroMagnetic Radiation Recorders
Re: Garage sale find : Shure 315 . But how do I diy the cable?
« Reply #1 on: December 01, 2017, 11:11:34 AM »
Yes, and either the Shure site or Coutant site should have the wiring diagram.  Nice find.  It won't like wind of any kind! 

 

RSS | Mobile
Page created in 0.091 seconds with 24 queries.
© 2002-2017 Taperssection.com
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company