Become a Site Supporter and Never see Ads again!

Author Topic: Help Identifying schoeps or off brand bars  (Read 295 times)

0 Members and 1 Guest are viewing this topic.

Offline twoodruff

  • Trade Count: (90)
  • Needs to get out more...
  • *****
  • Posts: 4683
  • Gender: Male
Help Identifying schoeps or off brand bars
« on: December 04, 2017, 01:52:22 PM »
I have two bars here, no mics to see any angles or what not,  my feeling is they are DINA and ORTF. Does some one have the time for me to send then to them to see what they are and if they needs them they can purchase or I will list them for sale in the proper forum. Thanks for your time.
No Mics
Clamps
Cables
No Preamp
Recorders

Offline yug du nord

  • uncleyug>Snowman>
  • Trade Count: (53)
  • Needs to get out more...
  • *****
  • Posts: 4966
  • made with natural flavor
Re: Help Identifying schoeps or off brand bars
« Reply #1 on: December 04, 2017, 02:20:14 PM »
I'm not it need of them....  but the flat "faces" of the DINA bar should be a 90* angle and the ORTF bar should be a 110* angle.
They are probably the same length, so you need to look at the angles to figure it out. 
.....got a blank space where my mind should be.....

Offline twoodruff

  • Trade Count: (90)
  • Needs to get out more...
  • *****
  • Posts: 4683
  • Gender: Male
Re: Help Identifying schoeps or off brand bars
« Reply #2 on: December 05, 2017, 09:40:13 AM »
I'm not it need of them....  but the flat "faces" of the DINA bar should be a 90* angle and the ORTF bar should be a 110* angle.
They are probably the same length, so you need to look at the angles to figure it out.

thanks a ton
No Mics
Clamps
Cables
No Preamp
Recorders

Offline achalsey

  • Trade Count: (28)
  • Needs to get out more...
  • *****
  • Posts: 2106
Re: Help Identifying schoeps or off brand bars
« Reply #3 on: December 05, 2017, 11:06:57 AM »
Just take anything in the house thats square and see if one of the corners lines up with where the mics would mounted to see if it's 90*.  A piece of paper is easy since you can adjust where the fold is to line up with the spacing on the bar.  You can search for what a 110* angle looks like online and just hold the bar up to the screen.

Then just take a ruler or measuring tape and eyeball about an inch or so off the bar to estimate where the diaphragm would be to get a rough estimate of the spacing.
« Last Edit: December 05, 2017, 11:10:03 AM by achalsey »

 

RSS | Mobile
Page created in 0.095 seconds with 26 queries.
© 2002-2017 Taperssection.com
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company