Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: diy charger???  (Read 1704 times)

0 Members and 1 Guest are viewing this topic.

Offline Krispy D

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4878
  • Gender: Male
    • my recordings on LMA
diy charger???
« on: February 06, 2006, 07:23:28 PM »
so I have a couple of 9.6v rc batts but no charger...

can I feed it 9v via a 1000mA ua5 wall wort AC adapter and just pull it after 4 hours or so?  the battery says quick charge with 1200 mA for 3.0 hours or regular charge with 600 mA for 6.5 hours.  is this gonna kill one of my batteries?  I'm gonna grab a smart charger but haven't gotten around to it yet.
Logged
Peluso CEMC6, ck4/ck21
Oktava MC012
Sony ECM260f
AT 811

canare star quads
DIY mil spec silvers

DIY (W-ish) mod UA5>JB3
Oade ACM PMD 660
R4


You cannot strengthen the weak by weakening the strong. You cannot help the wage-earner by pulling down the wage-payer. You cannot help the poor by destroying the rich. You cannot help men permanently by doing for them what they could and should do for themselves.
~Rev. William J. H. Boetcker (not Lincoln)

Offline udovdh

  • Trade Count: (0)
  • Taperssection Member
  • ***
  • Posts: 986
Re: diy charger???
« Reply #1 on: February 12, 2006, 05:35:13 AM »
Dunno if you are handy with electronics but you can get chips that are complete chargers with very few extra parts.
Check out http://www.maxim-ic.com/ for example.
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.065 seconds with 26 queries.
© 2002-2024 Taperssection.com
Powered by SMF