Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: jadedphan on March 20, 2018, 10:07:40 PM
-
Hey now,
I used to purchase bars for my schoeps caps from don (I think it was don) Kwon. I’m looking to see if he makes a mid-side bar. Also looking for someone making the equivalent quality products, if he’s no longer making them.
Thanks in advance,
-bry
-
Louie used to make what was referred to as a NOLA bar but I would look at the link below. If you don't find what you need then send Scott a massage and he will design one for you. The 3D printed bars are very sturdy and really light. It's not delrin but it's also not as expensive.
https://www.shapeways.com/shops/srsrecordingservices
-
I second the recommendation that you contact Scott @ SRS if he doesn't already have what you need. He will make any mic bar for you that you desire and he is a Schoeps user.
-
MS Schoeps Actives: https://www.shapeways.com/product/Y7HX83YLW/ms-schoeps-actives?optionId=61766538
This is the one he made for me: MS Schoeps + ORTF combo: https://www.shapeways.com/product/CXYZBM824/ms-ortf-schoeps-actives?optionId=63275660
-
Last time I ran into Robert Kwon he told me that he still has new old stock bars just not in every pattern and he was looking to sell what he had remaining.