Become a Site Supporter and Never see Ads again!

Author Topic: CA-11 or CA-14 with NO battery box into Tascam dr-2D mic in for high SPLs ?  (Read 2978 times)

0 Members and 1 Guest are viewing this topic.

Offline fandelive

  • Trade Count: (1)
  • Taperssection Member
  • ***
  • Posts: 480
  • I'm a llama!
Well, everything is in the title: anyone ever got a fine sounding tape when recording a loud show with CA-11 or CA-14 (omnis or cards) plugged directly into mic input of a Tascam dr-2D (or "mic in" from a device with similar specs) ?

Thanks!
« Last Edit: May 21, 2018, 05:34:07 AM by fandelive »
Mics : Sony ECM-717, MM-HLSC-1 (4.7k mod), SP-CMC-4 (at853), 2x DPA4060, 2x DPA4061
Battery box : SP-SPSB-6524 w/bass roll-off filter, MM-CBM-1
Preamp : Church Audio CA-9100
Recorders : Sony MZR-700PC, Edirol R-09HR, Tascam DR-2d

Offline beatkilla

  • Trade Count: (70)
  • Needs to get out more...
  • *****
  • Posts: 2104
  • Gender: Male
You need a Marantz PMD620 which has 5 volts plug in power or a Sony  PCM D100

Offline goodcooker

  • Trade Count: (43)
  • Needs to get out more...
  • *****
  • Posts: 4638
  • Gender: Male
  • goes to 11
You need a Marantz PMD620

Agreed. Years ago I recabled some DPA 4061s for a member here and took them out for a test run before returning them. I was curious about the plug in power available on my small deck deck - a PMD620 - and was surprised to see 4.8V worth of plug in power available. Most pocket recorders have around 3V or less.
Line Audio CM3/OM1 || MBHO KA500 hyper>PFA|| ADK A51 type IV || AKG C522XY
Oade Warm Mod and Presence+ Mod UA5s || Aerco MP2(needs help) || Neve Portico 5012 || Apogee MMP
SD Mixpre6 || Oade Concert Mod DR100mkii

pocket sized - CA11 cards > SP SB10 > Sony PCM A10

http://www.archive.org/bookmarks/goodcooker

"Are you the Zman?" - fan at Panic 10-08-10 Kansas City
"I don't know who left this perfectly good inflatable wook doll here, but if I'm blowing her up, I'm keeping her." -  hoppedup

Offline fandelive

  • Trade Count: (1)
  • Taperssection Member
  • ***
  • Posts: 480
  • I'm a llama!
You need a Marantz PMD620 which has 5 volts plug in power or a Sony  PCM D100

Thanks for replying. Tascam dr-2D user manual says it supports plug-in power, but gives no information about voltage.
I think I've read somewhere on this board that the Tascam mic input was equivalent to the Sony PCM D100, but I might be wrong...

Quote
Input/output ratings
Analog audio input/output ratings
MIC IN jacks (supporting plug-in power)
Connector: 1/8” (3.5 mm) stereo mini
Input impedance: 25 kΩ
Nominal input level:
GAIN LOW: –32 dBV
GAIN MID: –48 dBV
GAIN HIGH: –64 dBV

Maximum input level:
GAIN LOW: –16 dBV
GAIN MID: –32 dBV
GAIN HIGH: –48 dBV
LINE IN jacks
Connector: 1/8” (3.5 mm) stereo mini
Input impedance: 22 kΩ
Nominal input level: –10 dBV (0.32 V)
Minimum input level: –22 dBV (0.08 V)
Maximum input level: +6 dBV (2.0 V)
Mics : Sony ECM-717, MM-HLSC-1 (4.7k mod), SP-CMC-4 (at853), 2x DPA4060, 2x DPA4061
Battery box : SP-SPSB-6524 w/bass roll-off filter, MM-CBM-1
Preamp : Church Audio CA-9100
Recorders : Sony MZR-700PC, Edirol R-09HR, Tascam DR-2d

Offline Ziggz

  • Trade Count: (12)
  • Taperssection Member
  • ***
  • Posts: 479
This guy on Dime has some 2018 shows done with CA-14 -> M10 http://www.dimeadozen.org/account-details.php?id=92637

Video with CA14/M10 audio https://www.youtube.com/watch?v=KYZpsWfdUA0&feature=youtu.be

 

RSS | Mobile
Page created in 0.061 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF