Gear / Technical Help > Microphones & Setup
Microphone Repair? - TRS 1/4 tip solder - how to re attach - SHURE 580SA
(1/1)
Elguapo511:
I just pulled this from a garage sale and identified the problem. old solder....
just wondering how to re attach correctly.
What wire goes where? Anyone have experience with a mic like this?
Also, what is that tiny black wire? seems to be cut short.
The microphone works when I touch a few wires together. But wondering what the T section thinks.
Check the pics and thanks for the help
Elguapo511:
update.
just stripped it.
I am confused because there are three wires and I thought there would be two.
Do I twist two together?
Which does to the t and which to the S
morst:
I would say from this diagram that black gets tied to the case as ground, & white AND CABLE SHIELD is signal for the high-impedance SA model.
So yeah, tie white to cable shield and run black to the mic case and see if that's right?
The SB is different.
https://www.manualslib.com/manual/920228/Shure-Unidyne-580sa.html?page=2#manual
Navigation
[0] Message Index
Go to full version