Become a Site Supporter and Never see Ads again!

Author Topic: HELP-WTF: KM100s too large for a20s  (Read 7402 times)

0 Members and 1 Guest are viewing this topic.

Offline dmonterisi

  • Taper Emeritus
  • Site Supporter
  • Trade Count: (2)
  • Needs to get out more...
  • *
  • Posts: 11952
  • Gender: Male
  • Stomach Full of Regret
Re:HELP-WTF: KM100s too large for a20s
« Reply #15 on: September 18, 2003, 03:28:55 PM »
try to find someone that does it so that i don't cost you more shipping charges...maybe try the oade board as well.

rabhan

  • Guest
  • Trade Count: (0)
Re:HELP-WTF: KM100s too large for a20s
« Reply #16 on: September 18, 2003, 03:54:03 PM »
hrmmmmmm, that board gets no traffic

rabhan

  • Guest
  • Trade Count: (0)
Re:HELP-WTF: KM100s too large for a20s
« Reply #17 on: September 18, 2003, 04:49:24 PM »
alright, i just ordered some 8410s.

rabhan

  • Guest
  • Trade Count: (0)
Re:HELP-WTF: KM100s too large for a20s
« Reply #18 on: September 18, 2003, 04:49:41 PM »
thanks to all! +T

Offline dano420

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 104
  • llama I am...
Re:HELP-WTF: KM100s too large for a20s
« Reply #19 on: September 18, 2003, 09:56:41 PM »
I run the a20's with my KM140's. I hollowed out a big section of the clip so that it makes the clip that's left a bit weaker. It works great and haven't had any issues with the KM's since. I did have to put on the heavier elastic so that it would hold up the mic cable also.


rabhan

  • Guest
  • Trade Count: (0)
Re:HELP-WTF: KM100s too large for a20s
« Reply #20 on: September 18, 2003, 10:07:32 PM »
sweeet! +T i like it! did you use a dremel?

Offline dano420

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 104
  • llama I am...
Re:HELP-WTF: KM100s too large for a20s
« Reply #21 on: September 18, 2003, 10:11:17 PM »
I used a file that was the exact width that you see. A dremel would probably work better and look a little cleaner. My 140's pop right in and out of the clip now. You can also use the active cables and the ak40 capsule fits right in one side of the clip. Works very nice!

 

RSS | Mobile
Page created in 0.097 seconds with 35 queries.
© 2002-2024 Taperssection.com
Powered by SMF