Taperssection.com

Gear / Technical Help => Microphones & Setup => Topic started by: vwmule on March 17, 2019, 02:35:45 PM

Title: Replacement Manfrotto screw?
Post by: vwmule on March 17, 2019, 02:35:45 PM

Brought stand to Panic last night and noticed the locking screw was gone -- strange as I don't use the stand that often. Anyone know the replacement part number? I can't seem to find.

It's the red piece shown in picture.

https://www.bhphotovideo.com/c/product/644444-REG/Manfrotto_1004BAC_Alu_Master_3_Riser.html

Title: Re: Replacement Manfrotto screw?
Post by: perks on March 17, 2019, 09:15:08 PM

I think its in the diagram here....

https://www.manfrottospares.com/1004bac-parts.html

Title: Re: Replacement Manfrotto screw?
Post by: vwmule on March 17, 2019, 10:04:49 PM

Thanks. Says discontinued. I'll call B&H.

Title: Re: Replacement Manfrotto screw?
Post by: danny3 on March 19, 2019, 11:12:06 AM

I lost that same screw from the same stand at a festival a while back. After retracing my steps and scanning the ground for over an hour I gave up, only to find it in the grass below my tailgate.

Title: Re: Replacement Manfrotto screw?
Post by: tivva on March 25, 2019, 03:27:28 PM

Quote from: vwmule on March 17, 2019, 10:04:49 PM

Thanks. Says discontinued. I'll call B&H.

just go to your local hardware store...it's either fine or coarse thread?  might even have the correct wingnut size like i found....
total cost .89 cents...good luck!