Become a Site Supporter and Never see Ads again!

Author Topic: SHARP MD-MT180  (Read 8557 times)

0 Members and 1 Guest are viewing this topic.

Offline Swampy

  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 12020
  • Gender: Male
  • You Worthless Swampy Fool
Re:SHARP MD-MT180
« Reply #15 on: May 04, 2003, 08:12:47 PM »
So, if you take a new disc and do 'erase all' on it, it will do the same thing?

Offline blu666z

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 3277
  • AT ES943(H/C/O caps) » JKLab PP9 Pre » wmod UA-5
Re:SHARP MD-MT180
« Reply #16 on: May 05, 2003, 12:33:33 AM »
Do your own testing to make sure but that is what I found.  Recording several seconds of nothing or doing an erase all will force the deck to write/start the TOC and save time on the flip.

-Kevin

Offline blu666z

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 3277
  • AT ES943(H/C/O caps) » JKLab PP9 Pre » wmod UA-5
Re:SHARP MD-MT180
« Reply #17 on: May 05, 2003, 12:37:08 AM »
I was actually already in the habit of doing an 'erase all' but not for the good reason we have here.  The first few shows I did, it seemed like there were a lot of little pops/dropouts.  Figured it couldn't hurt to clear the disc beforehand and I haven't had a problem like that since.

-Kevin

Offline F.O.Bean

  • Team Schoeps Tapir that
  • Trade Count: (126)
  • Needs to get out more...
  • *****
  • Posts: 40690
  • Gender: Male
  • Taperus Maximus
    • MediaFire Recordings
Re:SHARP MD-MT180
« Reply #18 on: May 05, 2003, 01:26:26 AM »
go jb3 or dat....phuck phlips.... 8)

bean
Schoeps MK 4V & MK 41V ->
Schoeps 250|0 KCY's (x2) ->
Naiant +60v|Low Noise PFA's (x2) ->
DarkTrain Right Angle Stubby XLR's (x3) ->
Sound Devices MixPre-6 & MixPre-3

http://www.archive.org/bookmarks/diskobean
http://www.archive.org/bookmarks/Bean420
http://bt.etree.org/mytorrents.php
http://www.mediafire.com/folder/j9eu80jpuaubz/Recordings

 

RSS | Mobile
Page created in 0.141 seconds with 33 queries.
© 2002-2024 Taperssection.com
Powered by SMF