Become a Site Supporter and Never see Ads again!

Author Topic: wanted special cable for dound devices mix pre 3/6  (Read 290 times)

0 Members and 1 Guest are viewing this topic.

Offline tbone65

  • Trade Count: (4)
  • Taperssection Member
  • ***
  • Posts: 331
wanted special cable for dound devices mix pre 3/6
« on: October 30, 2017, 08:49:51 PM »
so here is what i want made.a cable that will go from a mix pre 3 battery sled.(4) battery size sled. to a 9 volt dvd battery. here is the issue. according to the sound device guys this deck  can only handle 8.4 volts. so will the extra .6 voltage blow the deck up? no one knows. i was told it shouldn't but if a cable with a attenuation  adapter inside the cable can be made then why not one with a voltage regulator? any ideas? lets discuss.  any one want to try to make ths?im sure there are a few folks on this board  who would want the made.ill ship out a sled to anyone who steps up to make this one happen.thanks .reach me at private email. todd1965@verizon.net    header read mix pre power cable. thank you.

 

RSS | Mobile
Page created in 0.071 seconds with 23 queries.
© 2002-2017 Taperssection.com
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company