Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: deleuze3 on November 06, 2015, 04:33:26 PM

Title: would you use tascam dr70d or pcm-m10 + sound devices or Pcm-m10 and CA ugly 2
Post by: deleuze3 on November 06, 2015, 04:33:26 PM
Hi

i use this setup : pcm-m10 + rode lavalier. I don't really have enough gain. I only use the rode lavalier to talk in it in front of a camera. Its to record my voice in different environement

I thought of other setups:

1) church audio ugly 2 + pcm-m10 + rode lavalier             (FOR MORE GAIN)
2) sound devices mp1 + pcm-m10 + rode lavalier              (FOR MORE GAIN)
3) tascam dr100mkii or tascam dr70d + pcm-m10 + rode ( FOR MORE GAIN)

I don't want to spend too much money, but i would like to upgrade my initial setting.

ANy thoughts ?
Thanks in advance
Deleuze3



Here are the specs of the pcm-m10
Active Electronics   JFET impedance converter
Capsule   0.10"
Address Type   End
Frequency Range   60Hz - 18kHz
Output Impedance   3000Ω
Maximum SPL   110dB SPL (@ 1kHz, 1% THD into 1KΩ load)
Maximum Output Level   189.0mV
Sensitivity   -33.5dB re 1 Volt/Pascal (21.00mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Equivalent Noise Level (A-weighted)   25dB-A
Title: Re: would you use tascam dr70d or pcm-m10 + sound devices or Pcm-m10 and CA ugly 2
Post by: CorFit Chris on February 24, 2016, 01:23:10 AM
It's been a few months since you posted this.  Did you figure it out, or do you still need some advice here?

Just an FYI on your 3rd setup.  Both of those Tascam products mentioned have their own phantom power, but I don't think their Plug-in power will be any different than the M-10.  I have a Pcm-M10 + CA Ugly + CA-14 and they work fine together.  If your interested in moving up in mics, there is someone in the Yard Sale looking to trade their Tascam DR-70 straight up for a Sony PCM-M10.  This would provide you the ability to use up to 4 condenser mics with phantom 48.
Title: Re: would you use tascam dr70d or pcm-m10 + sound devices or Pcm-m10 and CA ugly 2
Post by: willndmb on February 24, 2016, 11:41:38 PM
I would do #2
Not sure why you would even consider doing the tascam in front of the m10, just use the tascam all together if that's the case. Then again I wouldn't touch a dr70