Become a Site Supporter and Never see Ads again!

Author Topic: Microphone Repair? - TRS 1/4 tip solder - how to re attach - SHURE 580SA  (Read 1361 times)

0 Members and 1 Guest are viewing this topic.

Offline Elguapo511

  • Trade Count: (1)
  • Taperssection Regular
  • **
  • Posts: 92
I just pulled this from a garage sale and identified the problem.  old solder....

 just wondering how to re attach correctly.

What wire goes where?  Anyone have experience with a mic like this?

Also, what is that tiny black wire? seems to be cut short.

The microphone works when I touch a few wires together.  But wondering what the T section thinks.

Check the pics and thanks for the help
« Last Edit: August 05, 2018, 05:12:00 PM by Elguapo511 »

Offline Elguapo511

  • Trade Count: (1)
  • Taperssection Regular
  • **
  • Posts: 92

just stripped it.

I am confused because there are three wires and I thought there would be two.

Do I twist two together?

Which does to the t  and which to the S

Offline morst

  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 3416
  • ISO ALL archival Cracker / CVB / Monks Of Doom etc
    • Soundscape Preservation Society
I would say from this diagram that black gets tied to the case as ground, & white AND CABLE SHIELD is signal for the high-impedance SA model.

So yeah, tie white to cable shield and run black to the mic case and see if that's right?

The SB is different.
Teams: Neumann, Bay Area Tapers, Multitrack, Pioneertown Tapers, Mac Geeks, Cassette Masters, Poster Collectors, Alumni of teams St Louis, Upper Midwest & Milwaukee / Southern Wisco


RSS | Mobile
Page created in 0.069 seconds with 44 queries.
© 2002-2019
Powered by SMF