Become a Site Supporter and Never see Ads again!

Author Topic: I don't understand the range of volts  (Read 1096 times)

0 Members and 1 Guest are viewing this topic.

Offline intpseeker

  • Trade Count: (8)
  • Taperssection Member
  • ***
  • Posts: 791
  • Gender: Male
  • In music the passions enjoy themselves
I don't understand the range of volts
« on: February 21, 2009, 02:43:59 PM »
The Mini-mp states a range of 6-14 volts for external power supplies. Does this mean that as long as it gets a minimum of 6 volts, everything works as it should, but it is designed to handle supplies all the way up to 14 volts?
Mics:        Akg 451 eb A51's, ck-1's, ck-2's, ck 8's
                Peluso CEMC6 MK2, MK4, MK21, MK41
                AKG 391
                CA-11 cards and omnis
Pre:          ST-9100
Cables:     XTC Silvers, DT47-12's
Recorders: ACM PMD660
                 Busman modded R-4
                 PCM-M10
                 DR-70D
                 Church modded R-09 micsketeer
“One good thing about music, when it hits- you feel no pain” - Bob Marley

Offline Krispy D

  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4878
  • Gender: Male
    • my recordings on LMA
Re: I don't understand the range of volts
« Reply #1 on: February 21, 2009, 03:43:27 PM »
Hammer, meet nail.  Right on the head.  It means that the unit will function properly with a minimum voltage of 6 but not to exceed 14.
Peluso CEMC6, ck4/ck21
Oktava MC012
Sony ECM260f
AT 811

canare star quads
DIY mil spec silvers

DIY (W-ish) mod UA5>JB3
Oade ACM PMD 660
R4


You cannot strengthen the weak by weakening the strong. You cannot help the wage-earner by pulling down the wage-payer. You cannot help the poor by destroying the rich. You cannot help men permanently by doing for them what they could and should do for themselves.
~Rev. William J. H. Boetcker (not Lincoln)

Offline intpseeker

  • Trade Count: (8)
  • Taperssection Member
  • ***
  • Posts: 791
  • Gender: Male
  • In music the passions enjoy themselves
Re: I don't understand the range of volts
« Reply #2 on: February 21, 2009, 03:49:26 PM »
Thanks Kris.
Mics:        Akg 451 eb A51's, ck-1's, ck-2's, ck 8's
                Peluso CEMC6 MK2, MK4, MK21, MK41
                AKG 391
                CA-11 cards and omnis
Pre:          ST-9100
Cables:     XTC Silvers, DT47-12's
Recorders: ACM PMD660
                 Busman modded R-4
                 PCM-M10
                 DR-70D
                 Church modded R-09 micsketeer
“One good thing about music, when it hits- you feel no pain” - Bob Marley

 

RSS | Mobile
Page created in 0.065 seconds with 44 queries.
© 2002-2019 Taperssection.com
Powered by SMF