Become a Site Supporter and Never see Ads again!

Author Topic: Setting charging and discharging rates manually - Maha MH-C9000 question  (Read 2483 times)

0 Members and 1 Guest are viewing this topic.

Offline Drgiggles1

  • Trade Count: (2)
  • Taperssection Regular
  • **
  • Posts: 157
  • Gender: Male
Recently got a Maha MH-C9000 charger and was wondering if inserting Maha Powerex 2700 mAh AA's what rates do you recommend in the following 3 modes ?

Refresh and Analyze mode
Cycle mode
Discharge mode

Charge mode and Break-In mode I have no problem understanding, since really nothing needs to be done manually except for maybe entering the battery capacity. Just not quite sure on the above 3 modes listed. Thanks in advance.
Mics: CA-14 (o,c,o)
Remote Power: CA-9100 pre-amp, CA-UBB battery box
Recorders: Sony PCM-M10, Tascam DR-2d
Cable/s: custom 6" GAKables Mini Starquad
Batteries: Maha 9.6V Imedion, Maha Powerex 2700 mAh
Chargers: Maha MH-C9000, MAHA MH-C490F 9 Volt

Offline Drgiggles1

  • Trade Count: (2)
  • Taperssection Regular
  • **
  • Posts: 157
  • Gender: Male
Ok, think I figured it out after reading the instruction sheet for the 15th time over a period of days  ;D
For discharge rate I will use 300MA 540 MA for 2700mAh
For charging rate I will use 1000 MA for 2700 mAh

Any comments will be welcome.
« Last Edit: April 10, 2012, 01:07:16 PM by Drgiggles1 »
Mics: CA-14 (o,c,o)
Remote Power: CA-9100 pre-amp, CA-UBB battery box
Recorders: Sony PCM-M10, Tascam DR-2d
Cable/s: custom 6" GAKables Mini Starquad
Batteries: Maha 9.6V Imedion, Maha Powerex 2700 mAh
Chargers: Maha MH-C9000, MAHA MH-C490F 9 Volt

 

RSS | Mobile
Page created in 0.118 seconds with 29 queries.
© 2002-2018 Taperssection.com
Powered by SMF