Become a Site Supporter and Never see Ads again!

Author Topic: how to remove belt clip from ps-2  (Read 1504 times)

0 Members and 1 Guest are viewing this topic.

Offline weroflu

  • Trade Count: (5)
  • Taperssection Member
  • ***
  • Posts: 336
how to remove belt clip from ps-2
« on: December 30, 2013, 11:01:21 AM »
I tried the smallest hex key handy and it was maybe just a hair too small. Anyone know what size key to use to unscrew the clip?

Offline DSatz

  • Site Supporter
  • Trade Count: (35)
  • Needs to get out more...
  • *
  • Posts: 2880
  • Gender: Male
Re: how to remove belt clip from ps-2
« Reply #1 on: December 31, 2013, 10:41:58 AM »
My tools are all disorganized at the moment, but if you're dealing with a variety of equipment, you'll definitely need both a metric set of Allen wrenches and an "English" (fractions-of-an-inch) set. Most hardware stores have them for only a few bucks.

I'll post again later if I find my sets before anyone else posts the actual answer; I think I still have a PS-2 that I haven't removed the belt clip from.

--best regards
music > microphones > a recorder of some sort

Offline weroflu

  • Trade Count: (5)
  • Taperssection Member
  • ***
  • Posts: 336
Re: how to remove belt clip from ps-2
« Reply #2 on: December 31, 2013, 10:55:44 AM »
Thanks for the effort.

I just checked the sizes used. metric 1.5mm was too small and 2mm was too big.

Offline dnsacks

  • Trade Count: (9)
  • Taperssection All-Star
  • ****
  • Posts: 1643
Re: how to remove belt clip from ps-2
« Reply #3 on: December 31, 2013, 11:00:10 AM »
according to the chart found here http://www.vaughns-1-pagers.com/science/allen-wrench-conversion.htm, there are 2 SAE/english sizes between 1.5mm and 2mm (1/16" and 5/64") -- looks like it's time for a trip to the hardware store :)

 

RSS | Mobile
Page created in 0.078 seconds with 45 queries.
© 2002-2020 Taperssection.com
Powered by SMF