Become a Site Supporter and Never see Ads again!

Author Topic: Church UBB battery contact not snug  (Read 1612 times)

0 Members and 1 Guest are viewing this topic.

Offline beatkilla

  • Trade Count: (60)
  • Taperssection All-Star
  • ****
  • Posts: 1718
  • Gender: Male
Church UBB battery contact not snug
« on: April 21, 2015, 04:33:41 PM »
Anyway to resolve this?The negative part on Ubb is not a good fit,the 9 volt easily disconnects but stays fit on positive side.

Offline jagraham

  • Trade Count: (20)
  • Needs to get out more...
  • *****
  • Posts: 2836
  • Gender: Male
Re: Church UBB battery contact not snug
« Reply #1 on: April 21, 2015, 04:38:21 PM »
Owned 3 UBBs and never had this issue.
Mics: Nak CM-300s, Nak CM-100s, CP-1s, CP-2s, AT-853s(Cards, Hypers, Omnis) CA-14s(Cards, Omnis)
Pres: CA STC-9200, CA-UBB
Recorders: Tascam DR-70D, DR-2D, Edirol R-09

ISO: 1 Teac ME-120, CP-3 Caps, AT-853 Subcard Caps

Offline ilduclo

  • Trade Count: (4)
  • Needs to get out more...
  • *****
  • Posts: 5624
Re: Church UBB battery contact not snug
« Reply #2 on: April 21, 2015, 04:42:16 PM »
maybe sqeeze down the female sides with a pair of needle nose pliers? Both on the box and on the bat?

Offline dabbler

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 211
Re: Church UBB battery contact not snug
« Reply #3 on: April 23, 2015, 04:05:23 AM »
maybe sqeeze down the female sides with a pair of needle nose pliers? Both on the box and on the bat?
That.  You can move/adjust them a little as they'll loosen up over time.
I've needed to do that several times on various 9V-using things, not just audio equipment :)

 

RSS | Mobile
Page created in 0.099 seconds with 32 queries.
© 2002-2019 Taperssection.com
Powered by SMF