Become a Site Supporter and Never see Ads again!

Author Topic: Do I need a headphone amplifier?  (Read 481 times)

0 Members and 1 Guest are viewing this topic.

Offline pdastoor

  • Trade Count: (4)
  • Taperssection Regular
  • **
  • Posts: 157
Do I need a headphone amplifier?
« on: April 22, 2016, 12:31:33 AM »
Earlier on I was testing out my equipment to record voice for films and I could not hear any sound (very little) using my headphones even though the meter showed -24 dB.

Here is what I did. Rode NTG-2 plugged into a Sound Devices MP1 preamp, then the XLR from the preamp plugged into Tascam DRMK II. I had phantom power turned on with the pre and my gain was set all the way high on the pre. My levels on the tascam were on 0 and with that I could see -24 dB and i could see it was picking up sound but i could barely hear anything. Then I cranked up the levels on the tascam all the way and it was way too loud but I could hear everything.

On my pc I played back the file that was recorded with -24 dB and it sounded very good and clean and I could hear it well, just could not hear it properly when I was monitoring it on the tascam. Yes I had my volume levels all the way up.

What could be the issue? I have never used a headphone amp and am not sure if this is what I need. If so, could anyone recommend me one that I can use? Most of them have XLR slots, but my headphones are 3.5 mm

 

RSS | Mobile
Page created in 0.102 seconds with 28 queries.
© 2002-2017 Taperssection.com
Powered by SMF
Website Design by Foxtrot Media, Inc., a Baltimore Website Company