Become a Site Supporter and Never see Ads again!

Author Topic: 620 levels?  (Read 315 times)

0 Members and 1 Guest are viewing this topic.

Offline MakersMarc

  • Trade Count: (11)
  • Taperssection All-Star
  • ****
  • Posts: 1891
  • Gender: Male
  • Tucson AZ
620 levels?
« on: July 06, 2018, 06:10:39 PM »
Anyone run schoeps verticals>babynbox>Marantz 620? If so would love to know where you set levels for  >:D for soft stuff and loud rock up close. Thanks!
😈 Mk4v/41v>nbob actives>Baby nbox>Oade warm mod Marantz 620 or Sony M10.

Open: 4v/41v>nbobs>nbox platinum>620 or m10

Offline larrysellers

  • Trade Count: (35)
  • Needs to get out more...
  • *****
  • Posts: 2153
  • Gender: Male
  • Qualified
Re: 620 levels?
« Reply #1 on: July 06, 2018, 06:18:16 PM »
I would run between -20 and -10 but always with the pad engaged.

From ---> https://www.oade.com/Tapers_Section/faq-general.html

Quote
It's important to understand the MIC ATTN settings in the PMD 620 and 661 are not pads, they actually alter the gain of the preamp. Always use the least amount of gain that will allow you to get to 0dBFS, this means using the largest negative number (i.e. -18dB or -24dB). This does 2 things, it lowers noise and distortion plus it prevent input overload or "brickwalling". It's OK to set the PMD 620 or 661 record level control at 10 as long as your meters never show an over load. This is preferred to using a higher gain setting( smaller negative number) and setting the record level control to 6. If you cannot get enough signal level, then and only then switch to the next highest gain setting (i.e. -12dB)

Offline MakersMarc

  • Trade Count: (11)
  • Taperssection All-Star
  • ****
  • Posts: 1891
  • Gender: Male
  • Tucson AZ
Re: 620 levels?
« Reply #2 on: July 06, 2018, 08:08:42 PM »
Doug said run -24 what's I'm trying to figure out where to set the record level control, I didn't ask the question right.  :facepalm:
😈 Mk4v/41v>nbob actives>Baby nbox>Oade warm mod Marantz 620 or Sony M10.

Open: 4v/41v>nbobs>nbox platinum>620 or m10

Offline dointhatrag

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 108
  • Gender: Male
    • my band
Re: 620 levels?
« Reply #3 on: September 08, 2018, 09:57:43 AM »
I always cable mine into the line in jack. And i try not to let the levels go past 12 and then normalize in post. Mine is a Oade modded deck and this was his suggestion for concert recording. I find that works very well
Schoeps + Neumann + DPA - Sonosax PR - Apogee Mini Me - 24/96

 

RSS | Mobile
Page created in 0.154 seconds with 31 queries.
© 2002-2018 Taperssection.com
Powered by SMF