Become a Site Supporter and Never see Ads again!

Author Topic: Sonic Studios DSM-6 > PCM-M10 live metal show setup?  (Read 260 times)

0 Members and 1 Guest are viewing this topic.

Offline lushka

  • Trade Count: (1)
  • Taperssection Newbie
  • *
  • Posts: 47
Sonic Studios DSM-6 > PCM-M10 live metal show setup?
« on: October 01, 2018, 09:25:11 AM »
Greetings!

Did anyone run DSMs directly into an M10 recorder for a metal show, e.g. Sepultura?  Was wondering what levels to run to avoid clipping and excessive bass if any? Should I just use the low cut filter set to 'on' on the recorder or not? Any feedback would be highly appreciated.

Thanks
« Last Edit: October 01, 2018, 11:35:47 AM by lushka »

Offline seethreepo

  • Trade Count: (4)
  • Taperssection Member
  • ***
  • Posts: 745
  • Gender: Male
  • Rub it and see
Re: Sonic Studios DSM-6 > PCM-M10 live metal show setup?
« Reply #1 on: October 01, 2018, 02:00:24 PM »
I would avoid a low cut filter on the deck  try running mics line in, a better way to reduce the boom imho. Low cut in my experience can cause a phasing type sound on the recording as the deck adjusts the sound continually.
Mics: Sound Professionals - SP-CMC-8 , Studio Projects SPC4, Beyerdynamic ck930 , Marcsounds binaurals
Pre amps: Beyerdynamic MV-1 ,  Naiant IPA
Recorders:  Edirol R-44, Edirol R-09HR, Roland  R-05, Tascam  Dr-2d

Offline beatkilla

  • Trade Count: (49)
  • Taperssection All-Star
  • ****
  • Posts: 1611
  • Gender: Male
Re: Sonic Studios DSM-6 > PCM-M10 live metal show setup?
« Reply #2 on: October 01, 2018, 02:06:40 PM »
He is using the PIP of the M10 as it powers DSM correctly.
I have recorded the melvins with this method and do not try to stack tape.
You should go by the sbd area.

 

RSS | Mobile
Page created in 0.148 seconds with 30 queries.
© 2002-2018 Taperssection.com
Powered by SMF